Stringer DSpec & RSpec Civil3D – Released

DSpecPipes before

Stringer DSpec & RSpec

New features for DSpec – The enhancements made are only available with the xdata data storage.

The ODT data storage was too cumbersome and restrictive. This new feature will only work as stated above

  1. Pits – It is CRITICAL that Pits must be done first before doing the pipes. You can select a point in the drawing or right click to pick a point anywhere in the pit.
  2. Pipes -The programme now allows the user to select a line that is drawn from Invert Point to Invert Point.The levels of the points are used for the inverts, the length is calculated from the selected line, and then the line is altered to go from pit centre to pit centre as shown below.

This is the Pic of the pipe before attributed

DSpecPipes before

This is what the software does after attributing the Pipes

DSpecPipes after 1

If you would like to download the latest verson of Stringer from the Subscription website please go to the downloads page.

If you require assistance with gaining access to this site, please email